Intermec EasyCoder PD41 User Manual page 21

2 Load media as described in Chapter 2, "Loading Media".
3 Press and hold down the blue Print button.
4 Keep the Print button pressed down, and turn on the power
switch. After about ten seconds the printer enters Testmode
and three of the front LEDs start flashing one at a time.
5 Release the Print button at the appropriate time to establish
the media settings. Each of the LEDs (except the Power LED)
represent a media type according to the following table:
Setting the Paper Type
Flashing LED determines
Data/Ready
Error
Ready-to-Work
The printer will print several test labels containing the
printer's setup parameters. It will then enter Dumpmode.
6 Press the Print button once to exit Dumpmode.
EasyCoder PD41 Printer User's Guide
Green
Red
Blue
Chapter 1 — Getting Started
Media Type
Labels with gap
Tickets with black mark
Continuous stock
11