Datamax PE Operator's Manual page 44

Mbcfm!Pqujpot
(cont.)
Print Speed
*6.0 ips
Value range:
model dependent
Slew Speed
*8.0 ips
Value range:
model dependent
Backfeed Speed
*5.0 ips
Value range:
2.0 -5.0 ips
Label Width
*410 or
416, respectively
Value range:
Present Position
*245
Values range:
0 -999
34
Allows the selection of different rates that the label
will be printed.
PE 42; 2 to 10 ips (51 - 254 mm/sec)
PE 43; 2 to 8 ips (51 - 203 mm/ sec)
Allows the selection of different rates that the printer
will feed during non-printed portions of each label.
PE 42; 2 to 10 ips (51 to 254 mm/sec)
PE 43; 2 to 8 ips (51 - 203 mm/sec)
Allows the selection of different rates that the printer
will backup labels.
Range is the same for both models.
Changes useable label width, as when printing on
media narrower than 4.1 inches; reducing width
increases memory for label formatting. Also allows
printing of Configuration Labels on narrow media.
The printer must be reset for the new value to be
recognized.
PE 42; 100 to 410 (1.00 to 4.10 in.)
PE 43: 100 to 416 (1.00 to 4.16 in.)
Sets the label's stop point (Set Form Stop) after
printing. This value is independent of the Offset Bias
value (Start of Print Position), yet must be greater to
have any effect.
At default this function will have no effect on last
label positioning.
0.00 to 9.99 inches.
PE Series Operator's Manual