Datamax PE Operator's Manual page 46

Dpnqbubcjmjuz
Offset Bias
*220
110
Positioning
(PE 42 only)
*203 dpi
200 dpi
Host CMDS-Ignore
ProdigyPlus Mode
Pqfsbujpo
Pause Mode
*Disable
Enabled
Feedback Mode
*Disable
Enable
36
Three selections to control label positioning
Selects from two different Start of Print positions.
This command sets the point where printing starts,
relative to the Top-of-Form Adjust value. The
printer will feed from the Offset Bias and the Top-
of-Form Adjust value to begin printing.
Allows the selection of the column position
calculation based upon one of two different values.
Exact column positioning.
This parameter instructs the firmware whether to
process the DPL commands for Offset Position
(<stx>O), Peel Possition (<stx>f), and the Heat value
(stx>l>h)
This function sets the parameters so the printer will
emulate a Prodigy Plus printer. These parameters
are:
Offset Bias = 110
Positioning = 200DPI
Host Positioning = IGNORE
Conversion = Inches
Peel Position = .25" (1" if cutter is installed)
Sets three different operational functions.
Causes the printer to pause between printing each
label.
The 'Pause' button must be pushed in order to print
the next label.
Causes the printer to feedback ASCII characters 30
and 31.
The printer will return a 30 after each label is
printed and a 31 after each batch of labels.
PE Series Operator's Manual