Power Switch Assembly - HP ProDesk 600 G2 Small Form Factor Maintenance And Service Manual

Power switch assembly

1. Prepare the computer for disassembly
2. Remove the access panel
3. Remove the front bezel
4. Rotate the drive cage to its upright position
5. Disconnect the cable from the system board connector labeled PB/LED.
6. Remove the cable from the cable clips under the drive cage.
(Preparation for disassembly on page
(Access panel on page
(Front bezel on page 21).
(Rotating the drive cage on page
20).
19).
32).
Power switch assembly 53