Installing the Accessory Software under Windows 3.11
If your system runs Windows 3.11, you need to install the CD-ROM
driver, the sound board drivers, and the CD audio driver, as described
here.
Installing the CD-ROM Driver
Use the floppy disk included in the kit, labeled IDE CD-ROM drivers,
to install the CD-ROM driver.
1 Do not run Windows. If you are already in Windows, close it first.
2 Insert the floppy disk labeled IDE CD-ROM drivers in your flexible
disk drive.
3 At the MS-DOS prompt, type a:install
This installation program copies the CD-ROM driver to the
directory. (The driver is
4 When the installation program displays
AUTOEXEC.BAT (Y/N)?
The installation program adds this line to the CONFIG.SYS file:
•
DEVICE=C:\DEV\FDATACD.SYS /D:MSCD0HP
The installation program adds this line to the AUTOEXEC.BAT
•
file:
MSCDEX.EXE /D:MSCD0HP /M:12
If the
SMARTDRV
the parameter
/U
present. This parameter disables the SMARTDRV CD-ROM
caching.
1 Installing Your Multimedia Sound Kit
Installing the Accessory Software under Windows 3.11
.)
FDATACD.SYS
Modify CONFIG.SYS and
, type Y
statement is found in the AUTOEXEC.BAT file,
is added to the statement, if not already
.
C:\DEV
. (See also step 5.)
English 9