Installing The Accessory Software Under; Windows Nt 4.0; Installing The Cd-Rom Driver; Installing The Sound Board Drivers - HP Kayak XA Installation Manual

1 Installing Your Multimedia Sound Kit
Installing the Accessory Software under Windows NT 4.0

Installing the Accessory Software under

Windows NT 4.0

If your system runs Windows NT 4.0, you need to install the accessory
software as described here.

Installing the CD-ROM Driver

Windows NT 4.0 automatically detects the CD-ROM drive and loads
the required software driver when you switch on your PC.

Installing the Sound Board Drivers

To install the sound board drivers, complete the following steps.
1 With Windows NT running, insert the HP Multimedia Sound CD in
the CD-ROM drive. (Insert the CD label side up; press the open/close
pushbutton to open and close the drawer.)
2 Click on the Start button, point to Settings, then click on Control
Panel.
3 Double-click on the Add/Remove Programs icon
4 Click on the Install... button, and then the Next button.
5 Type d:\winnt\setup and then click on the Finish button. Follow
the instructions that appear on the screen.
(The CD-ROM drive may be your E drive. In this case you would
enter e:\winnt\setup. You can check by clicking the Browse
button in the Run Installation Program dialog box, and then
browsing to the CD-ROM drive.)
6 When the driver has been installed, you see the 16-bit Audio Board
Setup window.
7 Click on the OK button.
8 Restart the computer.
6 English
.