Installing The Cd-Rom Driver - HP Kayak XA Installation Manual

Installing the Accessory Software Under
Windows NT 3.51
If your system runs Windows NT 3.51, you need to install the accessory
software as described here.

Installing the CD-ROM Driver

1 Start Windows NT if it is not already running.
2 From the Main program group, double-click on the Windows NT
3 From the Options menu, select Add/Remove SCSI Adapters.
4 In the SCSI Adapter Setup window, click on Add and then click on
5 In the Adapter list in the Select SCSI Adapter Option window, select
6 Follow the instructions on the screen. You will be prompted to insert
7 When you have installed the CD-ROM driver, shut down and restart
NOTE If you are using Windows NT version 3.5 with the ATAPI driver version
1.2, you may notice an incompatibility problem when you perform a
warm reboot (Shutdown and then Restart without switching off). The
operating system may not recognize the CD-ROM drive. To correct this
problem, instead perform a cold reboot (switch the computer off and on
again). Upgrading to Windows NT version 3.51 will resolve the problem.
Setup icon .
OK at the advisory message to continue.
IDE CD-ROM (ATAPI 1.2)/Dual-channel PCI IDE
Install.
the correct Windows NT setup floppy disk containing the driver.
the computer for the driver to be loaded.
1 Installing Your Multimedia Sound Kit
Installing the Accessory Software Under Windows NT 3.51
and click on
English 7