Installing The Sound Board Drivers - HP Kayak XA Installation Manual

Installing the Sound Board Drivers

The following procedure installs the sound board drivers and also the
audio programs. For more information on these programs and on this
installation procedure, refer to the on-screen user's guide—page 20
tells you how to read the guide.
1 With Windows running, insert the HP Multimedia Sound CD in the
CD-ROM drive. (Insert the CD label side up; press the open/close
pushbutton to open and close the drawer.)
2 From the Program Manager, click on the File menu and click Run...
In the command line, type d:\win311\setup
follow the instructions that appear on the screen.
(The CD-ROM drive may be your E drive. In this case you would
enter e:\win311\setup
Browse button in the Run dialog box, and then clicking on the
Drives drop-down list.
During the installation you are asked to select either a "Full"
installation or a "Custom" installation. If you choose "Full", the
system files, DOS drivers, Windows drivers, and utilities are all
installed. If you choose "Custom", you have the opportunity to
install or to not install the DOS drivers, Windows drivers, and
utilities. The system files are always installed.
If you see the message "Configuration Manager not found", exit the
installation program as instructed. Install the ISA Configuration
Utility (ICU) and then run this audio software installation program
again. The ICU is required to configure the sound board settings.
(If you experience a problem with the ICU when trying to change
the sound board settings, it could be due to the version of your
BIOS. Call HP Support for assistance—the most recent version of
the BIOS is available on the HP BBS.)
1 Installing Your Multimedia Sound Kit
Installing the Accessory Software under Windows 3.11
. You can check by clicking the
and then
English 11