Beginning Assembly; Motor Brace - Grizzly G1035 Instruction Manual

Beginning Assembly

Disconnect power from
the machine when per-
forming any maintenance,
assembly or adjustments.
Failure to do this may
result in serious personal
injury.
Wear safety glasses dur-
ing the entire assembly
process. Failure to com-
ply may result in serious
personal injury.
Some
may have sharp edges
on them after they are
formed. Please examine
the edges of all metal
parts
them. Failure to do so
could result in injury.
Most of your Model G1035 Shaper has been
assembled at the factory, but some parts must
be assembled or installed after delivery. We
have organized the assembly process into steps.
Please follow those steps in the order presented
here.
TOOLS REQUIRED: You will need a 12" to 18"
long straightedge, 10, 12, and 14mm open end
wrenches, 3, 4 and 8mm Allen wrenches, and a
Phillips and flat head screwdriver.
G1035 Heavy-Duty Shaper
metal parts
before handling

Motor Brace

The Model G1035 is equipped with motor braces
to prevent damage to the motor during shipping.
These braces are intended to be removed before
operation.
To remove the motor braces:
1. Remove the motor cover from the shaper
cabinet by removing six screws that hold it in
place.
2. Using a 12mm wrench, remove the six hex
bolts, hex nuts and flat washers and the two
motor braces shown in Figure 4.
Figure 4. Motor braces and hex bolts.
-13-