Beginning Assembly; Switch Installation - Grizzly G0500 Owner's Manual

Beginning Assembly

This section will cover the minimum assembly
and adjustment instructions needed to begin
operation. For best results, complete the assem-
bly in the order provided in this manual and then
read the remaining portion of the manual before
attempting any type of operations.
Safety must come first! Read and follow these
instructions before beginning assembly:
Disconnect power to the
machine when perform-
ing all assembly steps.
Failure to do this may
result in serious person-
al injury.
Some metal parts may
have sharp edges on
them
formed. Please examine
the edges of all metal
parts before handling
them. Failure to do so
could result in injury.
Most of your 8'' Jointer has been assembled at
the factory, but some parts must be assembled or
installed after delivery.
TOOLS REQUIRED: You will need a high quality
square, a Phillips screwdriver, a long straight-
edge, 10mm, 12mm and 14mm open-end
wrenches, and a 3mm Allen wrench.
-16-
Wear safety glasses dur-
ing the entire assembly
process. Failure to com-
ply may result in serious
personal injury.
after they

Switch Installation

To install the switch:
1. Locate the #10-24 x 1
screws that are included in the hardware bag
with the switch.
2. Remove the switch cover by unthreading the
two plastic screws from the front of the
switch.
3. Position the switch over the holes and secure
it to the stand with the #10-24 x 1
head screws, as shown Figure 11.
Figure 11. Fastening switch to stand.
4. Place the cover back on the switch and
secure it to the switch body with the two plas-
are
tic screws.
5.
Locate the shortest length cord (motor cord)
and close a grommet around the wire, so the
larger end of the grommet is toward the
switch.
6. Thread the motor cord through the access
hole in the stand, which is located just below
the switch.
1
⁄ " Phillips head
2
G0500/G1018/G1018HW 8" Jointers
1 ⁄ " Phillips
2