When The Machine Does Not Print; Checking The Port Connection - Ricoh P7575 Operating Instructions Manual

Troubleshooting

When the Machine does Not Print

If the printing does not start even with printing instructions, check the following.
Possible Cause
Is the power on?
Is the machine online?
Does the printer function status indi-
cator remain red?
Is the paper set?
Can you print a configuration page?
Is the interface cable connected se-
curely to the machine and comput-
er?
Are you using the correct interface
cable?
Is the signal status satisfactory when
using wireless LAN ?
Is the Call-light blinking or lit?
If the problem cannot be resolved, contact your sales or service representative.

Checking the port connection

When the printer is directly connected via computer cable and the data-in indi-
cator does not flash or light up, port connection should be configured as follows:
• For parallel connection, set port LPT1 or LPT2.
• For a USB connection, set port USB00 (n)
Solutions
Check the power cord is securely plugged into both pow-
er outlet and machine.
Turn on the power switch.
If not, press [Online] on the display panel.
If so, check the error message on the display panel and
take appropriate action.
Set the paper in the paper tray or on the bypass tray
See p.55 "Paper and Other
If you cannot print a configuration page, there maybe a
machine malfunction. Contact your sales or service rep-
resentative.
See for printing a configuration page.
Connect the interface cable securely. If it has a fastener,
fasten that too.
The type of interface cable you should use depends on
the computer. Be sure to use the correct one. If the cable
is damaged or worn, replace it.
When using wireless LAN in ad hoc mode or 802.11b ad
hoc mode, move the machine to a location where radio
waves can pass or remove objects that might cause in-
terference.
When using wireless LAN in infrastructure mode, check
signal status using the [Maintenance]menu on the control
panel. If signal quality is poor, move the machine to a lo-
cation where radio waves can pass or remove objects
that might cause interference.
If a Call-light is installed, it notifies you of any errors that
occur during printing via its light. Check if the Call-light is
blinking or lit, and solve any errors. See
Lit or Blinking".
*1
.
Media".
p.95 "Call-light
96