Ricoh 5490 Operating Instructions Manual page 405

5 IP Address
6 Ethernet Speed
7 Network
8 I/O Timeout
9 I/O Buffer
10 Menu Reset
Sets the IP Address.
Note
❒ Default: 011.022.033.044
Reference
See the Printer Reference 1 for information about the IP Ad-
dress setting.
Sets the Ethernet communication speed.
Note
❒ Default: Auto
Sets the Network boot.
Note
❒ Default: NONE
Reference
See the Printer Reference 1 for information about the Net-
work boot setting.
Sets the time to enable the interface after data stops being re-
ceived. When the time set here is exceeded, it will be possible to
receive data from the other interface.
Important
❒ If the set time is too short, a time out might occur while one
data is being received. As a result, data from another inter-
face might cut in and be printed, or the emulation retrieval
from half of the data may be activated, and be replaced with
a different emulation.
Note
❒ Default: 30 sec.
Sets the capacity of the reception buffer.
Note
❒ Default: 512KB
You can reset the factory settings. However, the "IP Address",
"Network", and the "Ethernet Speed" settings do not change.
User Tools Menu
4
155