Ricoh 5490 Operating Instructions Manual page 344

Operation
Closed area method
Note
❒ The line designating the area must be a closed loop.
1
A A A A
Put the command sheet on top of the original.
B B B B
Using a black, red, or blue felt tip pen, draw a line around the area to des-
ignate. The line should have a thickness of at least 1mm.
Note
❒ Make sure there is no break in the line.
❒ Draw the line at least 2mm, 0.08", away from the image so that the whole
image can be recognized.
a = Line marking the designated area
b = 2mm, 0.08"
c = Image within the designated area
94
ZM-20
ZM-26