Ricoh 5490 Operating Instructions Manual page 186

Troubleshooting
- When a service call message is shown on the panel display -
- -
Press the [Exit] key. Then turn the main switch off and back on again. If a service
code appears again, contact your service representative.
Note
❒ If a service code appears on the panel display after you turn the main switch
off and on a few times, do not continue turning it on and off. Leave the ma-
chine off.
❒ When you make masters continuously using originals with solid images,
"SC-03-03" tends to appear on the panel display. In this case, turn off the main
switch and wait for a while. Then turn on the main switch.
5
166