Installing The 4Ge Ssm - Cisco WS-C5509 Hardware Installation Manual

Chapter 4 Maintenance and Upgrade Procedures
Table 4-1
2, 7
3, 8
4
5

Installing the 4GE SSM

To install a new 4GE SSM for the first time, perform the following steps:
Power off the adaptive security appliance.
Step 1
Locate the grounding strap from the accessory kit and fasten it to your wrist so that it contacts your bare
Step 2
skin. Attach the other end to the chassis.
Remove the two screws (as shown in
Step 3
cover.
Figure 4-18
Insert the 4GE SSM through the slot opening as shown in
Step 4
Figure 4-19
LN K
3
C is co
S S M -4
78-17989-01
4GE SSM LEDs
LED Color State
LINK Green Solid
Flashing
SPEED Off 10 MB
Green 100 MB
Amber 1000 MB (GigE)
POWER Green On
STATUS Green Flashing
Green Solid
Amber Solid
Removing the Screws from the Slot Cover
Inserting the 4GE SSM into the Slot
2
1
0
SP D
G E
Description
There is an Ethernet link.
There is Ethernet activity.
There is no network activity.
There is network activity at 100 Mbps.
There is network activity at 1000 Mbps.
The system has power.
The system is booting.
The system booted correctly.
The system diagnostics failed.
Figure 4-18) at the left rear end of the chassis, and remove the slot
LI NK
SP D
LI NK
3 SP D
LI NK
2 SP D
LI NK
1 SP D
0
Figure
LI NK
SP D
LI NK
3
SP D
LI NK
2
SP D
LI NK
1
Cisco ASA 5500 Series Hardware Installation Guide
Installing and Replacing the 4GE SSM
FL AS H
4-19.
FL AS H
SP D
0
4-15