Removing The Sfp Module - Cisco WS-C5509 Hardware Installation Manual

Chapter 4 Maintenance and Upgrade Procedures

Removing the SFP Module

The SFP modules have different types of latching devices used to detach the SFP module from a port.
The following are the different types of modules:
•
•
•
•
To remove the SFP module, perform the following steps:
Disconnect all cables from the SFP.
Step 1
Because invisible laser radiation may be emitted from the aperture of the port when no cable is
Warning
connected, avoid exposure to laser radiation and do not stare into open apertures. Statement 70
The latching mechanism used on many SFPs locks the SFP into place when cables are connected. Do not
Caution
pull on the cabling in an attempt to remove the SFP.
Step 2 Disconnect the SFP latch as shown in
Note
Figure 4-21
A
B
1
3
Grasp the SFP on both sides and remove it from the port.
Step 3
78-17989-01
Mylar Tab Module
Actuator/Button SFP Module
Bale-Clasp SFP Module
Plastic Collar Module
SFP modules use various latch designs to secure the module in the SFP port. Latch designs are not
linked to SFP model or technology type. For information on the SFP technology type and model, see
the label on the side of the SFP.
Disconnecting SFP Latch Mechanisms
1 2
Mylar tab 2 Actuator/Button
Bale-clasp 4 Plastic collar
Figure 4-21.
3
Cisco ASA 5500 Series Hardware Installation Guide
Installing and Replacing the 4GE SSM
4
4-19