Replacing The Aip/Csc Ssm - Cisco WS-C5509 Hardware Installation Manual

Chapter 4 Maintenance and Upgrade Procedures
Step 4 Insert the AIP/CSC SSM in to the slot opening as shown in
Figure 4-25 Inserting the AIP/CSC SSM into the Slot
Attach the screws to secure the AIP/CSC SSM to the chassis.
Step 5
Enter the hw-mod mod 1 reset command in privileged EXEC mode to reset the
Step 6
SSM.
Check the LEDs. If the AIP/CSC SSM is installed properly, the POWER LED is solid green and the
Step 7
STATUS LED flashes green.

Replacing the AIP/CSC SSM

To replace an existing AIP/CSC SSM, perform the following steps:
Enter the hw-mod mod 1 shut command in privileged EXEC mode. Verify that the module is down by
Step 1
making sure that the LEDs are all off.
Step 2 Locate the grounding strap from the accessory kit and fasten it to your wrist, so that it contacts your bare
skin. Attach the other end to the chassis.
Step 3 Remove the two screws at the left rear end of the chassis.
Step 4 Remove the AIP/CSC SSM. Place it in a static bag and set it aside.
Replace the existing card by inserting the new AIP/CSC SSM through the slot opening.
Step 5
Attach the screws to secure the AIP/CSC SSM to the chassis.
Step 6
Enter the hw-mod mod 1 reset command in privileged EXEC mode to reset the
Step 7
SSM.
Check the LEDs. If the AIP/CSC SSM is installed properly, the POWER LED is solid green and the
Step 8
STATUS LED flashes green.
Upgrading Memory in the Adaptive Security Appliance
This section describes how to upgrade the memory in the adaptive security appliance. The section
includes the following topics:
•
•
78-17989-01
Overview, page 4-24
Removing and Installing the DIMM, page 4-25
Upgrading Memory in the Adaptive Security Appliance
Figure
LI NK
SP D
LI NK
3
SP D
LI NK
2 SP D
LI NK
1 SP D
0
Cisco ASA 5500 Series Hardware Installation Guide
4-25.
AIP/CSC
AIP/CSC
4-23