C H A P T E R 4 Maintenance And Upgrade Procedures; Replacing The Chassis Cover; Removing And Replacing The Chassis Cover - Cisco WS-C5509 Hardware Installation Manual

Removing and Replacing the Chassis Cover

Before working on a system that has an On/Off switch, turn OFF the power and unplug the power cord.
Warning
Statement 1
Remove the screws from the top of the chassis
Step 3
Figure 4-1
Pull the top panel up as shown in
Step 4
Figure 4-2

Replacing the Chassis Cover

Do not operate the adaptive security appliance without the chassis cover installed. The chassis cover
Caution
protects the internal components, prevents electrical shorts, and provides proper air-flow for cooling the
electronic components.
To replace the chassis cover, perform the following steps:
Place the chassis on a secure surface with the front panel facing you.
Step 1
Cisco ASA 5500 Series Hardware Installation Guide
4-2
Removing the Top Panel Screws
POWER STATUS
Figure 4-2. Put the panel in a safe place.
Removing the Chassis Cover
POWER STATUS
Chapter 4 Maintenance and Upgrade Procedures
(Figure 4-1).
CISCO ASA 5540
Adaptive Security Appliance
ACTIVE VPN FLASH
CISCO ASA 5540
SERIES
Adaptive Security Appliance
ACTIVE VPN FLASH
SERIES
78-17989-01