Installing And Replacing The 4Ge Ssm; Overview - Cisco WS-C5509 Hardware Installation Manual

Installing and Replacing the 4GE SSM

Installing and Replacing the 4GE SSM
The 4GE SSM has four 10/100/1000 Mbps, copper, RJ-45 ports and four optional 1000 Mbps,
Small-Form-Factor Pluggable (SFP) fiber ports.
When using the 4GE SSM you can use the same numbered copper ports (RJ-45) and the SFP ports at the
Note
same time. Use the media-type command in interface configuration mode to set the media type to copper
or fiber Gigabit Ethernet. For a complete description of the command syntax, see the Cisco ASA 5500
Series Command Reference.
This section describes how to install and replace the 4GE SSM in the adaptive security appliance, and
includes the following topics:
•
•
•
•

Overview

Figure 4-17
Figure 4-17
1
2
3
4
Figure 4-17
Note
if you want to use this feature. For more information on SFP ports and modules, see the
Removing the SFP Modules" section on page
Table 4-1
Cisco ASA 5500 Series Hardware Installation Guide
4-14
Overview, page 4-14
Installing the 4GE SSM, page 4-15
Replacing the 4GE SSM, page 4-16
Installing and Removing the SFP Modules, page 4-16
lists the 4GE SSM ports and LEDs.
4GE SSM Ports and LEDs
2 3
LNK
3 2 1 0 SPD
Cisco SSM-4GE
4
1
RJ-45 ports
RJ-45 Link LED
RJ-45 Speed LED
Power LED
shows SFP modules installed in the ports slots. You must order and install the SFP modules
describes the 4GE SSM LEDs.
7 8
5
6
5 Status LED
6 SFP ports
7
SFP Link LED
8
SFP Speed LED
4-16.
Chapter 4 Maintenance and Upgrade Procedures
"Installing and
78-17989-01