Identifying The Country Code For Vg248 - Cisco VG248 - Gateway Software Configuration Manual

Identifying the Country Code for VG248

Tip

Identifying the Country Code for VG248

Step 1
Step 2
Step 3
Step 4
Step 5
Cisco VG248 Analog Phone Gateway Software Configuration Guide
3-6
1. When forward all is activated, users hear a distinctive dial tone to
indicate that all incoming calls are currently being forwarded to a
different directory number.
If you set a feature code to a blank string, users cannot use that feature.
•
• You cannot disable transfer or conference in standard mode because those
features are activated by hanging up or using the hook flash, rather than by
feature codes.
If you have two feature codes assigned to the same setting, one of the features
•
does not work.
If one feature code setting masks another, you cannot use the masked setting
•
(such as if transfer is * and conference is **, conference does not work).
The country code identifies the country in which you are using the VG248. It
automatically sets country-specific settings, such as the sound of the tones, the
cadence of the rings, impedance, hook flash timer, and gain, for example.
Follow these steps to set the country code,
From the main menu, choose Configure.
Choose Telephony.
Choose Country.
Choose the country name in which you are using the VG248.
If your country is not available, select a country that uses the same telephony
standards.
Restart the VG248.
Chapter 3 Configuring the Telephony Settings on the VG248
OL-1209-02