Cisco VG248 - Gateway Software Configuration Manual page 110

Troubleshooting Software Errors
Table 6-4 Cisco CallManager Errors and Warnings Explanation (continued)
System Error
SCCP TFTP failed; using
last known good
configuration
SCCP No TFTP server
address
SCCP Unable to resolve
TFTP server name
Cisco VG248 Analog Phone Gateway Software Configuration Guide
6-12
Explanation
A port on the VG248 has failed
to retrieve its configuration
using TFTP. Instead, the
VG248 is using the
configuration stored last time
the port successfully
registered with
Cisco CallManager.
The TFTP server has not been
set.
The VG248 was not able to
locate the TFTP server.
Chapter 6 Troubleshooting the VG248
Action
No action is required. However,
this message might indicate a
potential problem with
connectivity to the TFTP server.
Verify that the TFTP server is up
and running.
1. If using DHCP to obtain
TFTP server, check your
DHCP server configuration.
If you want to use a fixed
2.
TFTP server, you must
configure it on the VG248
Refer to the "Identifying the
Cisco CallManager TFTP
Server" section on page 3-2
to assign a TFTP server for
details.
Verify the name of the TFTP
server the VG248 is attempting
to locate using Display >
System Status.
If using DHCP, check the
•
configuration on the DHCP
server to verify that it is
returning a valid TFTP
server name to the VG248.
If you are using a fixed
•
TFTP server, verify the
configured server name
using Configure ->
Telephony > CallManager
TFTP server.
OL-1209-02