Summit X450E-48P Power Supplies; Internal Power Supply; External Power Supplies - Extreme Networks Summit X250e-24t Hardware Installation Manual

Summit family switches
Hide thumbs Also See for Summit X250e-24t:
Table of Contents

Advertisement

Summit Family Switches
Figure 46: Summit X450e-48p Switch Rear Panel
Management port
10 Gigabit
uplink option

Summit X450e-48p Power Supplies

The Summit X450e-48p switch is powered by both an internal power supply and an optional external
redundant power supply system.
Internal Power Supply. The internal Summit X450e-48p power supply is capable of 370 W of PoE power:
15.4 W supplied to each port for a 24-port configuration and 7.7 W supplied to each port for a 48-port
configuration or any combination of ports where total PoE power does not exceed 370 watts. If the total
system demands exceed this power limit, you can specify:
Port priorities to identify which ports should be ranked higher when allocating power
Port disconnect precedence to specify the method of shutting off ports when not enough PoE power
is available
NOTE
A full discussion of these concepts is in the ExtremeXOS 12.0 Concepts Guide, Power over Ethernet section.
External Power Supplies. The Summit X450e-48p switch can be powered by one, two, or three external
power modules through the redundant power input connector on the rear of the switch.
The EPS-C (External Power Supply Chassis) is shipped with the redundant power supply cable that
connects to the redundant input connector on the rear of the switch. The EPS-C chassis can hold from
one to three 600-Watt EPS-600LS (External Power Module) units.
The PoE capability of the Summit X450e-48p switch varies depending on the number of external power
modules in use.
on the number of power supply modules in use.
Table 10: Number of External PSUs and Corresponding PoE Behavior
Internal PSU
Status
Internal PSU:
Power On
Internal PSU:
Power Failure
For more information, see
56
supply connection
10 Gigabit
stacking ports
Table 10
summarizes the PoE power behavior for the Summit X450e-48p switch based
EPS-600LS (1x)
EPS-600LS (2x)
370 W of
740 W of
redundant power
external power only
Internal PSU disabled
370 W of
740 W of
external power only
external power only
"EPS-600LS External Power Module" on page
External power
EPS-600LS (3x)
740 W of
external power only
with 2:1 redundancy
Internal PSU disabled
740 W of
external power only
with 2:1 redundancy
Summit Family Switches Hardware Installation Guide
Power socket
SH_033
External PSU/Chassis
Failed/Disconnected
370 W of
internal power only
No PoE power
69.

Advertisement

Table of Contents
loading

Table of Contents