Label; Reset Button; Ethernet Management Port; Console Port - Extreme Networks Alpine 3802 Hardware Installation Manual

Consolidated “i” and “e” series
Hide thumbs Also See for Alpine 3802:
Table of Contents

Advertisement

provide a redundant, load-shared power source to the Summit5i switch. If one of the power sources or
power supplies fails, the second power supply provides all power needs which ensures uninterrupted
network operation.
NOTE
Only trained personnel should provide service for Summit5i switch power supplies.

Label

The label on the rear of the Summit5i switch displays important information about the switch. Write
down the following information before you install the switch:
• Model number—Model number assigned to this device
• Part number—Part number assigned to this device
• Serial number—Manufacturing serial number for this device. Refer to the serial number when you
contact Extreme Networks technical support.
• MAC address—Unique Ethernet MAC address assigned to this device

Reset Button

Use the reset button to cycle the switch down and bring the switch back up without powering off the
switch. Your saved switch configuration information is not lost; unsaved switch configurations are lost.
Use a non-conductive tool to push the reset button.

Ethernet Management Port

Use the management port (10/100 Mbps Ethernet, RJ-45 connector) to plug an Ethernet cable directly
from your laptop into the switch for out-of-band management. This port provides direct access into the
switch and allows you to view and locally manage the switch configurations.

Console Port

Use the console port (9-pin, "D" type connector) for local management. This port allows you to attach a
terminal and access the CLI through a serial connection.

Summit7i Switch

The Summit7i switch is 4U high; it is available in two port configurations:
• 28 autosensing 100BASE-TX/1000BASE-T ports with RJ-45 connectors and 4 1000BASE-X ports with
SC connectors (Figure 42)
• 28 1000BASE-SX ports with MT-RJ connectors and 4 1000BASE-SX ports with SC connectors
(Figure 43)
Extreme Networks Consolidated "i" and "e" Series Hardware Installation Guide
Summit7i Switch
93

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents