Specifying Vlans To Monitor - Cisco 4500M Software Manual

Configuring RSPAN

Specifying VLANs to Monitor

VLAN monitoring is similar to port monitoring. To specify VLANs to monitor, perform this task:
Command
Step 1
Switch# configure terminal
Step 2
Switch(config)# no monitor session
{ session_number | all | local |
remote}
Step 3
Switch(config)# [no] monitor session
{ session_number } {source {interface
interface_list | {vlan vlan_IDs | cpu
[queue queue_ids ]} [rx | tx | both]
Step 4
Switch(config)# monitor session
session_number destination remote
vlan vlan-id
Step 5
Switch(config)# end
Step 6
Switch# show monitor [session
session_number ]
Step 7
Switch# copy running-config
startup-config
To remove one or more source VLANs from the RSPAN session, use the no monitor session
session_number source vlan vlan-id rx global configuration command.
Software Configuration Guide—Release 12.2(25)EW
39-22
Purpose
Enters global configuration mode.
Clears any existing SPAN configuration for the session.
For session_number, specifies the session number identified with this
RSPAN session (1 through 6).
Specify all to remove all SPAN sessions, local to remove all local
sessions, or remote to remove all remote SPAN sessions.
Specifies the RSPAN session and the source VLANs (monitored
VLANs). You can monitor only received (rx) traffic on VLANs.
For session_number, specifies the session number identified with this
RSPAN session (1 through 6).
For interface-list, specifies the source port to no longer monitor. Valid
interfaces include physical interfaces and port-channel logical
interfaces (port-channel port-channel-number).
For vlan-IDs, the range is 1 to 4094; do not enter leading zeros.
For queue_ids, specifies the source queue.
(Optional) [, | -] Specifies a series or range of interfaces. Enter a space
after the comma; enter a space before and after the hyphen.
(Optional) Specifies the direction of traffic to monitor. If you do not
specify a traffic direction, the source interface sends both transmitted
(Tx) and received (Rx) traffic. Only received traffic can be monitored
on additional source ports.
Rx—Monitor received traffic.
•
Tx—Monitor transmitted traffic.
•
• both—Monitor both received and transmitted traffic
(bidirectional).
Specifies the RSPAN session, the destination remote VLAN.
For session_number, specifies the session number identified with this
RSPAN session (1 through 6).
For vlan-id, specifies the RSPAN VLAN to carry the monitored traffic
to the destination port.
Returns to privileged EXEC mode.
Verifies your entries.
(Optional) Saves your entries in the configuration file.
Chapter 39 Configuring SPAN and RSPAN
OL-6696-01