Cisco 4500M Software Manual page 21

Preface
This preface describes who should read this document, how it is organized, and its conventions. The
preface also tells you how to obtain Cisco documents, as well as how to obtain technical assistance.
Audience
This guide is for experienced network administrators who are responsible for configuring and
maintaining Catalyst 4500 series switches.
Organization
This guide is organized into the following chapters:
Chapter
Chapter 1
Chapter 2
Chapter 3
Chapter 4
Chapter 5
Chapter 6
Chapter 7
Chapter 8
Chapter 9
OL-6696-01
Title
Product Overview
Command-Line Interfaces
Configuring the Switch for the
First Time
Configuring Interfaces
Checking Port Status and
Connectivity
Configuring Supervisor Engine
Redundancy Using RPR and SSO
Environmental Monitoring and
Power Management
Configuring Power over Ethernet
Configuring Switches with
Web-based Tools
Description
Presents an overview of the Cisco IOS software for
the Catalyst 4500 series switches
Describes how to use the CLI
Describes how to perform a baseline configuration
of the switch
Describes how to configure non-layer-specific
features on Fast Ethernet, Gigabit Ethernet, and
10-Gigabit Ethernet interfaces
Describes how to check module and interface status
Describes how to configure RPR and SSO on the
Catalyst 4507R and 4510R switches
Describes how to configure power management and
environmental monitoring features
Describes how to configure Power over Ethernet
(PoE)
Describes how to install and configure Network
Assistant and Embedded CiscoView
Software Configuration Guide—Release 12.2(25)EW
xxi