Default 802.1X Configuration - Cisco 4500M Software Manual

How to Configure 802.1X

Default 802.1X Configuration

Table 31-1
Table 31-1 Default 802.1X Configuration
Feature
Authentication, authorization, and accounting (AAA)
RADIUS server
• IP address
UDP authentication port
•
Key
•
Per-interface 802.1X protocol enable state
Periodic reauthentication
Time between reauthentication attempts
Quiet period
Retransmission time
Maximum retransmission number
Multiple host support
Client timeout period
Authentication server timeout period
Software Configuration Guide—Release 12.2(25)EW
31-12
shows the default 802.1X configuration.
Default Setting
Disabled
•
•
•
Disabled (force-authorized)
The port transmits and receives normal traffic without
802.1X-based authentication of the client.
Disabled
3600 sec
60 sec
Number of seconds that the switch remains in the quiet state
following a failed authentication exchange with the client.
30 sec
Number of seconds that the switch should wait for a response to an
EAP request/identity frame from the client before retransmitting the
request.
2
Number of times that the switch will send an EAP-request/identity
frame before restarting the authentication process.
Disabled
30 sec
When relaying a request from the authentication server to the client,
the amount of time that the switch waits for a response before
retransmitting the request to the client.
30 sec
When relaying a response from the client to the authentication
server, the amount of time that the switch waits for a reply before
retransmitting the response to the server. This setting is not
configurable.
Chapter 31 Understanding and Configuring 802.1X Port-Based Authentication
None specified
1812
None specified
OL-6696-01