Isdn Bri U Wan Interface Cards - Cisco 1601 - Router - EN Hardware Installation Manual

ISDN BRI WAN Interface Cards
To connect an ISDN BRI S/T WIC to a network, follow these steps:
Confirm that the router is turned off.
Step 1
To comply with the Telcordia GR-1089 NEBS standard for electromagnetic compatibility and safety,
Caution
connect the 1-port ISDN BRI WIC with S/T interface, version 3 (WIC-1B-S/T-V3) only to intra-building
or non-exposed wiring or cabling. The intrabuilding cable must be shielded and the shield must be
grounded at both ends.
Connect one end of a straight-through RJ-48C-to-RJ-48C cable to the RJ-48C port on the ISDN BRI S/T
Step 2
WIC.
Connect the other end of the cable to the NT1 device, as shown in
Step 3
Figure 48
Straight-through
RJ-48C-to-RJ-48C
cable
Connect the NT1 device to the ISDN wall jack according to the documentation that came with the NT1
Step 4
device.
Turn on power to the router.
Step 5
Check that the OK LED goes on, which indicates that the ISDN port has established a connection with
Step 6
the central office switch.

ISDN BRI U WAN Interface Cards

This section describes how to connect ISDN BRI U WICs to a network and contains the following
sections:
•
•
•
•
Connecting an ISDN BRI S/T WIC to an NT1 Device
SEE MANU AL BEFOR E INSTA LLATIO
BRI S/T port (RJ-48C)
ISDN BRI U WICs Overview
ISDN BRI U WIC LEDs
Prerequisites for Connecting an ISDN BRI U WIC to a Network
Connecting an ISDN BRI U WIC to a Network
Figure
BRI
S/T
N
NT1 device
S/T port
ISDN BRI U WAN Interface Cards
48.
OL-12844-01
5