G.shdsl Wics - Cisco 1601 - Router - EN Hardware Installation Manual

DSL Interface Cards

G.SHDSL WICs

The Multirate Symmetrical High-Speed Digital Subscriber Line (G.SHDSL) cards support two or more
DSL lines.
The G.SHDSL WICs are available in the following variations:
•
•
To comply with the Telcordia GR-1089 NEBS standard for electromagnetic compatibility and safety,
Caution
connect the 1-port G.SHDSL interface card (WIC-1SHDSL-V2 and WIC-1SHDSL-V3) only to
intra-building or non-exposed wiring or cabling. The intrabuilding cable must be shielded and the shield
must be grounded at both ends.
LEDs on G.SHDSL WICs
The ADSL and G.SHDSL WICs have three LEDs, which are shown in
Table
Figure 63
WIC
1SHDSL V2
Table 15
LED
CD LED
LP LED
The WIC-1SHDSL is a 1-port interface card that supports one pair of copper wire (2-wire
G.SHDSL). It is compatible with Cisco G.SHDSL line cards in the Cisco 6015, Cisco 6130,
Cisco 6160, or Cisco 6260 digital subscriber line access multiplexer (DSLAM).
The WIC-1SHDSL-V2 and WIC-1SHDSL-V3 interface cards are 1-port cards. They support all
G.SHDSL features, and supply two twisted pairs of wires to implement 4-wire (two-line) G.SHDSL.
These WICs support dying gasp and wetting current. They also provide a higher symmetrical
bandwidth and longer reach than 2-wire G.SHDSL.
15.
G.SHDSL WIC Front Panels
SEE MANUAL
BEFORE INSTALLATION
CD LP OK
ADSL ADSL
SEE MANUAL
BEFORE INSTALLATION
CD LP OK
ADSL
SEE MANUAL
BEFORE INSTALLATION
LINK LP OK
SHDSL
G.SHDSL WIC LEDs
Color Description
Green Lit when the unit is connected to the network and operating normally. On
ADSL interface cards only, this LED blinks while training with DSLAMs.
Does not apply to the WIC-1SHDSL-V2 or WIC-1SHDSL-V3 interface cards.
Yellow DSL interface is in loopback mode.
Off Normal operation.
WIC
1ADSL
SHDSL
WIC
1ADSL IDG
ADSL
Figure 63 and are described in
SEE MANUAL
BEFORE INSTALLATION
WIC
1SHDSL
CD LP OK
SEE MANUAL
BEFORE INSTALLATION
WIC
1ADSL DG
CD LP OK
OL-12846-01
G.SHDSL WICs
3