Supported Platforms - Cisco 1601 - Router - EN Hardware Installation Manual

DSU/CSU WAN Interface Cards
Connecting a T1/FT1 DSU/CSU WIC to a Network
To connect a T1/FT1 DSU/CSU WIC to a network, follow these steps:
Confirm that the router is turned off.
Step 1
To comply with the Telcordia GR-1089 NEBS standard for electromagnetic compatibility and safety,
Caution
connect the 1-port T1/FT1 DSU/CSU WIC, version 2 (WIC-1DSU-T1-V2) only to intra-building or
non-exposed wiring or cabling. The intrabuilding cable must be shielded and the shield must be
grounded at both ends.
Connect one end of the straight-through RJ-48C-to-RJ-48C cable to the RJ-48C port on the T1/FT1
Step 2
DSU/CSU WIC.
Connect the other end of the cable to the T1 wall jack, as shown in
Step 3
Figure 61
Turn on power to the router.
Step 4
Check that the CD LED comes on, which means that the internal DSU/CSU is communicating with the
Step 5
DSU/CSU at the T1 service provider's central office.

Supported Platforms

For a list of the platforms supported by a Cisco interface card refer to
Interface
Finding Support Information for Platforms and Cisco IOS Software Images
Use Cisco Feature Navigator to find information about platform support and Cisco IOS software image
support. Access Cisco Feature Navigator at http://www.cisco.com/go/fn. You must have an account on
Cisco.com. If you do not have an account or have forgotten your username or password, click Cancel at
the login dialog box and follow the instructions that appear.
Connecting the T1/FT1 DSU/CSU WIC to a T1 Wall Jack
T1 port
(RJ-48C)
LOOP
SEE MANU AL BACK
BEFO RE
INSTA LLATI ON
DSU
CSU
LP
AL CD
T1 DSU/ CSU
T1
Straight-through
RJ-48C-to-RJ-48C cable
Cards.
T1 (RJ-48C)
wall jack
Supported Platforms
Figure 61.
Platform Support for Cisco
OL-12845-01
7