Installing Cisco Interface Cards in Cisco Access Routers
Installing Slot Dividers in Cisco 2811, Cisco 2821, Cisco 2851, and Cisco 3825 Series Routers
To install a slot divider in Cisco 2811, Cisco 2821, Cisco 2851, and Cisco 3825 series routers, perform
the following steps:
Remove any installed interface cards and blank faceplates from the router slot you plan to use.
Step 1
Guide the two halves of the slot divider between the two rails in the bottom of the interface card slot.
Step 2
(See
Push the slot divider in until it seats and locks into place. When the slot divider is fully seated, its outer
Step 3
end is flush with the front panel of the router. (See
Figure 21
Step 4
Gently pull the slot divider to check for complete seating. If properly seated, it does not come out. (See
Figure
Figure
21.)
Inserting a Slot Divider into an Interface Card Slot
22.)
Installing Cisco Interface Cards in Cisco Access Routers
Figure
22.)
OL-12842-01
11