Receive And Transmit (E&M) Interface Cards - Cisco 1601 - Router - EN Hardware Installation Manual

Voice Interface Cards
Connecting FXO Cards
Use a straight-through RJ-11 cable to connect the FXO voice interface card to the PSTN or PBX through
a telephone wall outlet.
Ports on this interface card are colored pink.
Note
Step 1 Confirm that the router is still turned off.
Caution To comply with the Telcordia GR-1089 NEBS standard for electromagnetic compatibility and safety,
connect the 2-port FXO card (VIC2-2FXO) only to intra-building or non-exposed wiring or cabling. The
intrabuilding cable must be shielded and the shield must be grounded at both ends.
Connect one end of the straight-through RJ-11 cable to an RJ-11 port on the card. (See
Step 2
Figure 86
VIC
FXS
Straight-through
RJ-11-to-RJ-11 cable
Connect the other end to an RJ-11 telephone wall outlet.
Step 3
Receive and Transmit (E&M) Interface Cards
RecEive and transMit (E&M) is a signaling technique for two-wire and four-wire telephone and trunk
interfaces. The E&M interface typically connects remote calls from an IP network to a PBX. The cards
are illustrated in
Caution To comply with the Telcordia GR-1089 NEBS standard for electromagnetic compatibility and safety,
connect the 2-port E&M card (VIC2-2E/M) only to intra-building or non-exposed wiring or cabling. The
intrabuilding cable must be shielded and the shield must be grounded at both ends.
Connecting an FXO Card
RJ-11 ports
1
SEE MAN UAL BEF ORE INST
0
ALLA TION
Figure 87 and Figure
RJ-11 wall jack
88.
Receive and Transmit (E&M) Interface Cards
Figure
OL-12847-01
86.)
7