Configuring The Isdn Bri Interface - Cisco CISCO2515-RF - 2515 Router User Manual

Configuring the Router for the First Time
Table 4-1
Country
Australia
Europe
Japan
New Zealand
North America
Configuring the ISDN BRI Interface
This section describes how to configure the ISDN BRI interface. If your router does not
include an ISDN BRI interface, proceed to the next section, "Configuring Ethernet or Token
Ring Interfaces."
The ISDN BRI interface is configured to allow connection to ISDN WANs. Determine
which protocols to support on the ISDN BRI interface and enter the appropriate responses.
In the following example, the system is configured for IP, AppleTalk, and IPX:
Configuring interface BRI0:
Is this interface in use? [yes]
Configure IP on this interface? [yes]
IP address for this interface: 172.16.71.1
Number of bits in subnet field [0]: 8
Class B network is 172.16.0.0, 8 subnet bits; mask is
4-8 Router Installation and Configuration Guide
ISDN Switch Types
ISDN Switch Type
basic-ts013
basic-1tr6
basic-nwnet3
basic-net3
basic-net5
vn2
vn3
ntt
basic-nznet3
basic-5ess
basic-dms100
basic-ni1
255.255.255.0
Description
Australian TS013 switches
German 1TR6 ISDN switches
Norwegian NET3 ISDN switches (phase 1)
NET3 ISDN switches (UK and others)
NET5 switches (UK and Europe)
French VN2 ISDN switches
French VN3 ISDN switches
Japanese NTT ISDN switches
New Zealand NET3 switches
AT&T basic rate switches
NT DMS-100 basic rate switches
National ISDN-1 switches