Vlan Commands Set - TRENDnet TEG-S811FI User Manual

aggregator group
[GroupID] [Port-list]
nolacp
show aggregator
no aggregator lacp
[GroupID]
no aggregator group
[GroupID]

VLAN Commands Set

Trendnet Commands
vlan database
Vlanmode
comma(ex.2, 3, 6)
[Workport]: The
amount of work ports,
this value could not be
less than zero or be
large than the amount
of member ports.
G Assign a static trunk
group.
[GroupID] :1~3
[Port-list]:Member port
list, This parameter
could be a port
range(ex.1-4) or a port
list separate by a
comma(ex.2, 3, 6)
Show the information
P
of trunk group
G Disable the LACP
function of trunk group
G Remove a trunk group switch(config)#no aggreator
Level Description
P Enter VLAN configure
mode
V To set switch VLAN
24
switch(config)#aggregator group
1 2-4 nolacp
or
switch(config)#aggregator group
1 3,1,2 nolacp
switch#show aggregator 1
or
switch#show aggregator 2
or
switch#show aggregator 3
switch(config)#no aggreator lacp
1
group 2
Example
switch#vlan database
switch(vlan)#vlanmode portbase