Part names
Ports (See below.)
AUDIO IN3 L/R port (14)
(In the default setting, the
AUDIO IN3 L/R port is the audio
port for the VIDEO, S-VIDEO
and COMPONENT VIDEO
ports, however it is possible to
change the settings. 38)
COMPONENT
VIDEO ports (14)
Y
C
/P
B
B
C
/P
R
R
VIDEO port (14)
S-VIDEO port (14)
AUDIO IN port (13)
(In the default setting, the AUDIO
IN port is the audio port for
the RGB IN port, however, it is
possible to change the settings.
38)
NOTE (*) About Restart switch: This projector is controlled by an internal
microprocessor. Under certain exceptional circumstances, the projector may not
operate correctly and the microprocessor will need to be reset. In such a case,
please push the Restart switch by using a cocktail stick or similar, and before
turning on again, make the projector cool down at least 0 minutes without
operating. Only push the Restart switch in these exceptional instances.
6
Rear-Left side
AUDIO IN port (13)
(In the default setting, the AUDIO IN port is the audio
port for the RGB IN port, however, it is possible to
change the settings. 38)
RGB IN port (13)
Restart switch (*) (66)
RGB IN port (13)
SD CARD
AUX I/O
AUDIO IN3
Y
R
RGB IN1
RGB IN2
AUDIO IN1
C
P
/
B
B
L
AUDIO IN2
C
P
R
/
R
CONTROL
K
VIDEO
S-VIDEO
CONTROL port (13)
Kensington lock slot
Power switch (19)
AC inlet (15)
Elevator button (10)
Elevator foot (10)
Vent
SD CARD slot (13)
This slot is used when
utilizing SD CARD.
AUX I /O port (13)
This port is used when
utilizing USB Memory.
LAN
LAN port (13)
Used for Ethernet
RGB OUT
AUDIO OUT
input/output.
This port is used
when utilizing network
USB
functions.
Ports
RGB OUT port (13)
USB port (13)
AUDIO OUT port
(13)