Convenient Functions; Hdmi Control Function - Denon AVR-2309CI Owner's Manual

ENGLISH

Convenient Functions

HDMI Control Function

When AVR-2309CI is connected to a TV and player compatible with
HDMI control function, you can perform the following operations.
Settings other than AVR-2309CI settings must be made on the respective
devices. (Check the operating instructions of each device for details.)
AVR-2309CI power off can be linked to the TV power off step.
•
When you set "Output audio from amp" in the TV audio output setup
operation, you can switch the amp power on.
You can switch audio output devices with a TV operation.
•
(When outputting from the TV speakers, output switches from
speakers connected to AVR-2309CI).
You can adjust AVR-2309CI volume in the TV volume adjustment
•
operation.
You can switch AVR-2309CI input source through linkage to TV input
•
switching.
When playing the player, the AVR-2309CI input function switches to
•
the function of that player.
• When you want to listen to TV audio by AVR-2309CI, connect optical
digital or analog (vpage 11).
If the TV you are using has both connection jacks, use the optical
digital connection.
• When using these functions set as follows: menu "Manual Setup"
– "HDMI Setup" – "HDMI Control" set to "ON" (vpage 26).
NOTE
When using the HDMI control function, do not assign HDMI input to "TV/
CBL" by setting "Input Setup" – "Assign" – "HDMI In" in the menu.

Operations
1
Connect the HDMI to the AVR-2309CI with equipment
compatible with the HDMI control function.
2
Put the power on for all the equipment connected to
the HDMI.
3
Check the settings for all the equipment connected to
the HDMI and make HDMI available to them.
b Please consult the operating instructions for the connected
equipment to check the settings.
b Steps 1~3 do not have to be repeated once started.
b Carryout steps 2 and 3 should any of the equipment be plugged
out.
4
Switch the television input to the HDMI connected to
the AVR-2309CI.
5
Switch the AVR-2309CI input to the HDMI input
source and check if the picture from the player is ok.
6
Put the television power on standby and check if the
AVR-2309CI goes into standby.
If the AVR-2309CI does not work please check the following.
• Is the menu "Manual Setup" – "HDMI Setup" – "HDMI Control"
(vpage 26) set to "ON"?
• Is the menu "Manual Setup" – "HDMI Setup" – "Power Off Control"
(vpage 26) set to "ON"?
• Is the control function used for the television HDMI properly set?
(Check the television operating instructions for details.)
• Should any of the operations below be performed, the interlocking
function may be reset, in which case, repeat step's 2 and 3.
Menu "Input Setup" – "Assign" – "HDMI In" (vpage 35) setting
•
has changed.
There is a change to the connection between the equipment and
•
the HDMI, or an increase in equipment.
NOTE
When you power off AVR-2309CI, the HDMI control function does not
operate. Either power on or set to standby.
Symbols used to indicate buttons in this manual
Button located on both the main unit and the remote control
unit
Button only on the main unit
Button only on the remote control unit
<SPEAKERS>
<INPUT MODE>
<POWER> QUICK SELECT
QUICK SELECT
[Front]
uiop
[Rear]
uiop
BUTTON
<BUTTON>
[BUTTON]
ui
<SELECT/ENTER>,
op
[CH SELECT/
ENTER]
ENTER