Convenient Functions; Channel Level; Quick Select Function; Personal Memory Plus Function - Denon AVR-1508 Owner's Manual

• To cancel, press <REC SELECT>, then turn <SOURCE SELECT> until
"RECOUT SOURCE" is displayed.
• Make a test recording before starting the actual recording.
NOTE
• Recordings you make are for your personal enjoyment and should
not be used for other purposes without permission of the copyright
holder.
• Digital signals are not output from the REC OUT (CDR/TAPE and
VCR) connector.

Convenient Functions

Channel Level

You can adjust the channel level either according to the playback
sources or to suit your taste, as described below.
1
<ENTER> [CH SELECT]
Press or .
F L V o l . + 1 . 5 d B
2
<ENTER> [CH SELECT]
Use ui, or
speaker.
The speaker that can be set switches each time one of the
buttons is pressed.
3
Use o p to adjust the volume.
b "OFF" can be set by pressing o when the subwoofer's volume is
set to –12 dB.

Quick Select Function

With this function, the currently playing input source, input mode,
surround mode, room EQ settings and volume can be stored in
the memory.
1
Set the input source, input mode, surround mode,
room EQ settings and volume to the conditions you
want to store.
2
Press and hold
appears on the display.
[Quick Select Defaults]
Quick Select 1
Quick Select 2
Quick Select 3
To call out the settings, press QUICK SELECT at which the desired
settings were stored.

Personal Memory Plus Function

to select the
This function sets the settings (input mode, surround mode, etc.)
last selected for the individual input sources.
When you switch to an input source, the settings are automatically
set to the ones that were set the last time that input source was
used.
The surround parameters, tone control, room EQ settings and the
volumes of the different speakers are stored for the individual surround
modes.
QUICK SELECT
until "Memory"
Input Source Volume
DVD/HDP –40 dB
TV/CBL –40 dB
VCR –40 dB

Last Function Memory

This stores the settings as they were directly before the standby
mode was set.
When the power is turned back on, the settings are restored to as
they were directly before the standby mode was set.

Backup Memory

The various settings are backed up for about 1 week, even if the
power is turned off or the power cord is disconnected.

Resetting the Microprocessor

Perform this procedure if the display is abnormal or if operations
cannot be performed.
When the microprocessor is reset, all the settings are reset to
their default values.
1
<POWER>
Turn off the power using
2
<POWER>
Press while simultaneously pressing
<SPEAKER A> <SPEAKER B>
and
3
Once the display starts flashing at intervals of about 1
second, release the two buttons.
If in step 3 the display does not flash at intervals of about 1 second,
start over from step 1.
ENGLISH
.
.