Checking The Sirius Signal Strength And Radio; Presetting Radio Channels (Preset Memory); Listening To Preset Channels - Denon AVR-2309CI Owner's Manual

ENGLISH
Symbols used to indicate buttons in this manual
Button located on both the main unit and the remote control
unit
Button only on the main unit
Button only on the remote control unit
<SOURCE SELECT> <STATUS>
<ON/STANDBY> SHIFT
[Front]
[OFF]
[iPod]
SHIFT
TUNING
[CHANNEL + −]
uiop
[SOURCE
CONTROL 1]
[Rear]
[iPod]
[TUNING + −]
[MODE]
[MEMORY]

Checking the SIRIUS Signal Strength
and Radio ID
BUTTON
1
Either turn
<BUTTON>
to select "SIRIUS".
[BUTTON]
2
<STATUS>
Press
display.
TUNING
ui
The display will switch as shown below, depending on the
reception conditions.
Display
EXCELLENT
GOOD
WEAK
NO SIGNAL
3
Adjust the position of the antenna until "SIGNAL:
EXCELLENT" is shown on the display.
op
4
<STATUS>
Press
(example: "SR001") is displayed.
5
TUNING
Press
[SAT TU1/2]
Channel No. and Sirius ID are alternately shown on the display.
SR000 SiriusID
b Write your own SIRIUS ID for storage use.
Sirius ID :
[ENTER]
The strength of both the SIRIUS and terrestrial signals can be checked
at menu "Input Setup" – "Antenna Aiming" (vpage 36).
[SOURCE
CONTROL 2]
[SAT TU 1/2]
uiop
[ENTER]
<SOURCE SELECT> [SAT TU 1/2]
or press
until "SIGNAL" appears on the
Status
Signal strength is excellent
Signal strength is good
Signal strength is weak
No signal
until the channel you want to check
and select channel 0 (SR000).
Sirius ID
************
Presetting Radio Channels
(Preset Memory)
Your favorite broadcast channels can be preset so that you can
tune them in easily. Up to 56 channels can be preset.
1
Tune in the broadcast channel you want to preset.
2
[MEMORY]
Press .
3
SHIFT
Press to select the block (A to G) in which the
channel is to be preset.
4
<PRESET> [CHANNEL + –]
Press or
number (1 to 8).
5
[MEMORY]
Press again to complete the setting.
To preset other channels, repeat steps 1 to 5.
NOTE
Preset channels are erased by overwriting them.

Listening to Preset Channels

1
SIHFT
Press to select the memory block (A to G).
2
<PRESET> [CHANNEL + –]
Press or
desired preset channel (1 to 8).
to select the preset
to select the