Tone; Audyssey Settings - Denon AVR-2309CI Owner's Manual

A4 SB CH Out
(Selectable displays during 2-channel source playback.)
Determine whether to use surround back speakers.
[Selectable items]
ON
: The surround back channel signal is played.
OFF
: The surround back channel signal is not played.
A5 SUBWOOFER ATT
Attenuate subwoofer level when using EXT. IN mode.
[Selectable items]
ON
: The input from the subwoofer channel is attenuated.
OFF
: The input from the subwoofer channel is not attenuated.
Usually use in this mode.
Set this to "ON" if the subwoofer channel level seems too high when
playing audio signal.
Subwoofer
A6
Turn subwoofer output on and off.
[Selectable items]
ON
: The subwoofer is used.
OFF
: The subwoofer is not used.

Tone

Adjust the tonal quality of the sound.
A7 Tone Control
Turn tone adjustments off.
[Selectable items]
ON
: Allow tone adjustment (treble, bass).
OFF
: Playback without tone adjustment.
The tone cannot be adjusted when in the DIRECT mode.
NOTE
When the "Dynamic EQ" setting is "ON" , setting is not possible.
A8 Bass
Adjust low frequency range (bass).
[Variable range] –6dB ~ 0dB ~ +6dB
A9 Treble
Adjust high frequency range (treble).
–6dB ~ 0dB ~ +6dB
[Variable range]
"Bass" and "Treble" can be set when "Tone Control" is set to "ON" .
For details on adjusting individual parameters, see "Adjusting the parameters" (vpage 39).

Audyssey Settings

Select MultEQ, Dynamic EQ and Dynamic Volume.
S0 MultEQ
Select the type of correction desired from the following list:
[Selectable items]
Audyssey
: Optimize frequency response of all speakers.
Audyssey Byp. L/R
: Optimize frequency response of speakers
except front L and R speakers.
Audyssey Flat
: Optimize frequency response of all speakers
to flat response.
Manual
: Apply frequency response set with "Manual
EQ" (vpage 28).
OFF
: Turn equalizer off.
Audyssey Audyssey Byp. L/R
OFF Manual Audyssey Flat
Operating from the main unit or main remote
control unit
MULTEQ
Press .
• When "Audyssey", "Audyssey Byp. L/R" or "Audyssey Flat" is
selected, " " lights.
• After running Auto Setup, if the Speaker Configuration, Distance,
Channel Level, and Crossover Frequency have changed without
increasing the number of speakers measured, only "
lights.
• "Audyssey", "Audyssey Byp. L/R" and "Audyssey Flat" can be
selected after the auto setup procedure has been performed.
• After performing "Auto Setup", the "MultEQ" setting automatically
becomes "Audyssey".
• If the settings of speakers for which "None" has been determined
at "Auto Setup" are changed, "Audyssey" , "Audyssey Byp. L/R" and
"Audyssey Flat" cannot be selected. Either perform Auto Setup
again, or return to the setting after running Auto Setup with "Auto
Setup" – "Parameter Check" – "Restore".
• MultEQ and Manual EQ set to "Not Used" with "Manual Setup"
– "Audio Setup" – "EQ Preset" – "EQ Customize" (vpage 28) on
the menu, cannot be selected.
• When using headphones, "MultEQ" is set to "OFF" .
ENGLISH
"