Playback In The Pure Direct Mode; Parameter; Adjusting The Parameters - Denon AVR-2309CI Owner's Manual

ENGLISH
Operating from the main unit
<SELECT/ENTER>
Use to select the surround mode.
n
During PCM (2ch) / Analog / DOLBY DIGITAL (2ch)
DIRECT STEREO DOLBY PRO LOGIC gx
(DOLBY PRO LOGIC g)
neural z
7CH STEREO
(5CH STEREO)
ROCK ARENA JAZZ CLUB
VIRTUAL MATRIX
z : It is possible to play analog input signals and PCM (2-channel, 48
kHz or less) in the surround mode.
n
During Digital (Multi channel)
DIRECT STEREO
ROCK ARENA
7CH STEREO
(5CH STEREO)
JAZZ CLUB
VIRTUAL MATRIX

Playback in the PURE DIRECT Mode

This is the mode that recreates the original sound most faithfully,
providing extremely high quality sound.
[PURE DIRECT]
Press .
[PURE DIRECT]
• To cancel, press again.
• When in the PURE DIRECT mode, the on-screen display is not
displayed and the display on the main unit is turned off.
• If the HDMI input connector is selected, video outputs are output in
the PURE DIRECT mode.
• The channel level and surround parameters in the PURE DIRECT
mode are the same as in the DIRECT mode.


Parameter

Symbols used to indicate buttons in this manual
DTS NEO:6
Button located on both the main unit and the remote control
unit
MONO MOVIE
Button only on the main unit
VIDEO GAME
Button only on the remote control unit
STANDARD
(Dolby Digital, DTS, etc)
MONO MOVIE
VIDEO GAME
[Front]
[AUDIO DELAY]
CONTROL 1]
[Rear]
[A. MENU]
<BUTTON>
RESTORER MULTEQ <MENU>
DYNAMIC VOLUME RETURN ENTER, op
ENTER
[NIGHT]
uiop
DYNAMIC
MULTEQ
VOLUME
RESTORER
[SOURCE
[MUSIC]
[CINEMA] [STANDARD]
ENTER
uiop
RETURN

Adjusting the parameters

1
<MENU> [A.MENU]
Press or
BUTTON
The menu is displayed.
[BUTTON] b To operate from the main remote control unit, be sure to set the
[SOURCE CONTROL 1]
to "AUDIO".
2
Use ui to select which "Parameter", then press
ui
ENTER
.
3
To change the setting:
Press ui to select the item you want to change, then
o p
press to change the setting.
b To return to the previous item, press
b Select "Default Yes", then press o to reset to the default
setting.
4
ENTER
Press to enter the setting.
n To exit adjustment
<MENU> [A.MENU]
Press or
.
RETURN
.
during adjustment.