Preparations - Denon AVR-2309CI Owner's Manual

Auto Setup
Symbols used to indicate buttons in this manual
Button located on both the main unit and the remote control
unit
Button only on the main unit
Button only on the remote control unit
SETUP MIC jack MASTER VOLUME ui
RETURN
[Front]
MASTER VOLUME
[Rear]
ENTER
uio
RETURN
®
• Audyssey MultEQ automatically measures the acoustical problems
in the listening environment to create the best audio experience for
your home theater.
• Audyssey MultEQ optimizes a large listening area where one or
BUTTON
more listeners are seated.
<BUTTON>
Measurements are performed by placing the calibrated microphone
[BUTTON]
(DM-A409) successively at multiple positions throughout the
listening area as shown in Example q. For best results, it is strongly
recommended to measure 6 positions so that the measurements
have the proper spatial weighting.
Even if the listening environment is small as shown in Example w,
measuring at multiple points throughout the listening environment
results in more effective correction.
Example q
( :Measuring positions)
ENTER,o
*
M
About the main listening position (*M)
The main listening position refers to the most central position where
one would normally sit within the listening environment.
MultEQ uses the measurements from this position to calculate
speaker distance, level, polarity, and the optimum crossover value
for the subwoofer.
To make manual adjustments to the settings, see pages 24 ~ 26.

Preparations

1
Connect the included calibrated setup microphone to
the SETUP MIC jack on the main unit.
The auto setup screen appears automatically.
Sound
receptor
2
Place the microphone at ear height on a tripod or stand
Example w
with the microphone pointing directly up towards the
ceiling.
*
M
b Do not hold the microphone in your hand during measurements.
Be sure that the path from microphone to the speakers is not
blocked by objects. Avoid placing the microphone close to a seat
back or wall as sound refl ections may give inaccurate results.
When using a subwoofer, make the following settings before starting
the auto setup procedure:
• Defeat the volume and crossover controls if possible
• If this is not possible then set
Volume: "12 o'clock" position
•
Crossover frequency: "Maximum/Highest Frequency"
•
Low pass fi lter: "Off"
•
Standby mode: "Off"
•
NOTE
• Do not disconnect the setup microphone until the auto setup
procedure is completed.
• When using headphones, unplug the headphones before starting
the auto setup procedure.
ENGLISH
Setup
microphone
0