DES-3226L Layer 2
The following parameters can be set:
Parameter
Community Name
View Name
Access Right
SNMP Host Table
Use the SNMP Host Table to set up SNMP trap recipients.
Open the Basic Setup folder to Network Management, and then the SNMPV3 folder.
Finally, click on the SNMP Host Table link. This will open the SNMP Host Table page, as
shown below.
To delete an existing SNMP Host Table entry, click the corresponding radio button entry and
then the Delete button.
To add a new entry to the switch's SNMP Group Table, click the New button in the upper
left-hand corner of the SNMP Host Table page. This will open the SNMP Host Table - Add
page, as shown below.
Fast Ethernet Switch User's Guide
Description
Type an alphanumeric string of up to 33 characters that is used to identify
members of an SNMP community. This string is used like a password to
give remote SNMP managers access to MIB objects in the Switch's
SNMP agent.
Type an alphanumeric string of up to 32 characters that is used to identify
the group of MIB objects that a remote SNMP manager is allowed to
access on the Switch. The view name must exist in the SNMP View
Table.
read_only − Specifies that SNMP community members using the
community string created with this command can only read the contents
of the MIBs on the Switch.
read_write − Specifies that SNMP community members using the
community string created with this command can read from and write to
the contents of the MIBs on the Switch.
Figure 5-18. SNMP Host Table window
39