Omniswitch 6800-48 Front Panel - Alcatel OS6850-48L Getting Started Manual

OmniSwitch 6800-48 Front Panel

Status and Slot Indicator LEDs
For detailed information on OS6800-48
status and slot indicator LEDs, refer to
page 58.
OmniSwitch 6800-48
TM
Speed 1 3 5 7
OK PRI
PWR BPS
FAN TMP
XFP1 XFP2
Speed 2 4 6 8
54 Hardware Basics
9 11 13 15 17 19
10 12 14 16 18 20
10/100/1000Mbps Ports
The OS6800-48 provides 44 fixed 10/100/1000BaseT
ports (1–44) and 4 fixed 10/100/1000BaseT combo
ports (45–48). These ports are auto-sensing and auto-
MDIX and use RJ-45 connectors.
Combo SFP Ports
The OS6800-48 provides four combo SFP slots for 1000Base-X high-speed
connections.
By default, when an SFP is installed in a combo port, it takes over the port
number of the corresponding RJ-45 Ethernet port. In other words, if an SFP
is installed in the slot labeled 45, Ethernet port 45 is no longer available and
cannot be used for 10/100/1000 traffic. This default setting is referred to as
"preferred fiber." Refer to "Configuring Ethernet Ports" in the Network
Configuration Guide for detailed information, including steps for configur-
ing combo port settings.
21 23 25 27 29 31
22 24 26 28 30 32
33 35 37 39 41 43
34 36 38 40 42 44
Console Port
The OS6800-48 front panel provides one
RJ-45 port for console connections. Con-
sole connections are used by network
administrators for switch management.
This female RJ-45 connector provides a
DTE console connection.
45 47 LINK/ACT
45 47
45
47
46
46 48 LINK/ACT 48
Console
46 48
October 2006