Identifying External Components; Front Panel; Rear Panel - TRENDnet TEG-240WS - DATA SHEETS User Manual

IDENTIFYING EXTERNAL COMPONENTS

This chapter describes the front panel, rear panel, and LED indicators
of the Switch.

Front Panel

The figure below shows the front panels of the Switch.
Figure 4. Front panel of 24-port Gigabit Ethernet Switch
LED Indicator:
Comprehensive LED indicators display the status of the switch and
the network (see the LED Indicators chapter below).
Gigabit Ethernet Ports (Port 1~24):
The Switch twenty-four Gigabit twisted pair ports, supported auto negotiable
10/100/1000Mbps and auto MDI/MDIX crossover detection function, this
function gives true "plug and play" capability, just need to plug-in the
network cable to the hub directly and don't care if the end node is NIC
(Network Interface Card) or switch and hub.
half-duplex mode for 10/100Mbps
10/100/1000Mbps.
Note: When the port was set to "Forced Mode", the Auto
MDI/MDIX will be disabled.
These ports can operate in
and full- duplex mode
13

Rear Panel

AC Power Connector:
This is a three-pronged connector that supports the power cord. Plug
in the female connector of the provided power cord into this connector,
and the male into a power outlet. Supported input voltages range from
100-240V AC at 50-60Hz.
Reset:
The Reset button is to reset all the setting back to the factory default.
Note: Be sure that you recorded the setting of your device, else all the
setting will be erased when pressing the "Reset" button.
for
Figure 5. Rear panel of the Switch
14