Table of Contents Table of Contents English ...................... 1. Before You Start ................2. Hardware Installation ................ 3. Web Management Utility ..............Troubleshooting ..................Version 07.29.2008...
1. Before You Start Package Contents TEG-160WS/TEG-240WS Quick Installation Guide Utility & User Guide CD-ROM 2 Mounting Brackets with Screws Power Cord System Requirements Web Browser: Internet Explorer (5.0 or above), Netscape (6.0 or above) Computer with Network adapter installed Optional Mini-GBIC modules (e.g.
"admin". Make sure your computer and the TEG-160WS/TEG-240WS are configured to the same network segment. 2. The Mini-GBIC slots are shared with Port 15 and 16 (TEG-160WS) and port 23 and 24 (TEG-240WS) Gigabit Ethernet ports. When the Mini-GBIC slots are in use, port 15 and 16 (TEG-160WS) and port 23 and 24 (TEG-240WS) Gigabit Ethernet ports are disabled.
3. Web Management Utility Note: If you would like to easily discover all the Web Management Switches on the network, assign IP Address, change the password, and upgrade to new firmware, then install the Web Management Utility. Follow the steps below. For Windows User 1.
Page 6
4. Click Discovery, and then double- click the Switch that appears in the Discovery List. 5. Click the Switch in the Monitor List and then click Configuration setting. 6. Configure the IP Address, Subnet mask, Gateway, and Password. Click Set. English...
Page 7
For more information regarding the Web-based Smart Utility configuration and advanced settings, please refer to the User's Guide included on the Utility & Driver CD-ROM or TRENDnet's website at www.trendnet.com Register Your Product To ensure the highest level of customer service and support, please take a moment to www.TRENDnet.com/register...
TEG-160WS/TEG-240WS. The default IP Address of the Switch is 192.168.0.1 and the default password is admin. When I access the TEG-160WS/TEG-240WS using a web browser, I get a screen that tells me “only one user can login”. What should I do? Another computer is configuring the TEG-160WS/TEG-240WS.
Page 9
Certifications This equipment has been tested and found to comply with FCC and CE Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received. Including interference that may cause undesired operation.