Removing The Network Board - Canon LBP-5100 User Manual

15
Install the network board.
16
Connect the interface cables except for the USB cable, and
connect the power cord.
17
Plug the power plug into the AC power outlet.
18
If you are going to print via USB also, connect the USB cable
as needed.

Removing the Network Board

Remove the network board using the following procedure. Have ready the
protective plate and screws for the expansion slot removed when the network board
was installed.
CAUTION
• • • • Be sure to turn the printer and computer OFF and disconnect all the interface
cables and power cord from the printer before removing the network board. If a
USB cable is connected, turn the computer off, and then remove the USB cable.
If you attempt to remove the network board when the printer is ON or any cable
is connected to the printer, this may result in an electrical shock.
• • • • Be careful when handling the network board. Touching the edges or a sharp
portion of the network board may result in personal injury.
Network Board 8-31
8