Troubleshooting - Fagor IF-900S Manual To Installation

C60T376A8.qxd 14/3/07 16:21 Página 21

TROUBLESHOOTING

YOU FIND THAT
The induction plate does
not work. The lights on the
keypad are off.
Trip switches are activated
when you switch it on.
When you connect the
appliance to the network a
light appears.
The plate gives off a smell
when you cook on it for the
first few times.
The plate does not
work and a message
appears.
The plate does not work
and this information
appears
The plate stops working, it
beeps every 10 seconds
and or F7 appears on
screen.
This type of symbol
F7 appears.
After switching on a hob,
the keypad lights continue
to flash.
Pans make a noise during
cooking. The hob plate
makes crackling noises
during cooking.
The ventilation continues
for a few minutes after
switching off the hob
plate.
POSSIBLE CAUSES
The appliance is not
receiving any power. The
power supply or
connection is faulty.
Connection to your hob
plate is faulty.
Normal operation.
New appliance
The electronics circuit
does not work properly.
The plate is locked.
There has been an
overflow or an object is
obstructing the command
panel.
or The electronic circuits
have overheated.
The recipient used is not
suitable for induction or its
diameter is less than
12 cm (10 cm on
16 cm hob).
Normal with some types of
recipients. This is due the
energy passing from the
plate to the recipient.
Cooling the
electronics.
Normal operation.
21
WHAT TO DO
Check the electrical
installation.
Check fuses and trip
switches.
Check connection
conformity.
Nothing, the message will
disappear after 30
seconds.
Heat a pan of water on
each hob for 1/2 hour.
Ring the Technical Service.
See child safety chapter.
Clean or remove the
object and start cooking
again.
See framing chapter.
See chapter on recipients
for induction.
Nothing. There is no
risk for the plate or the
recipient.
Nothing.