Fagor IF-900S Manual To Installation page 15

C60T376A8.qxd 14/3/07 16:21 Página 12
OFFSET PROGRAMMING
This allows you to adjust the finishing time and the duration of this cooking session.
IMPORTANT
Offset programming cannot be used at the same time on more than one hob.
The chosen finishing, duration and power values must be changed whilst the digits are
flashing.
1. Switch on the hob of your choice, using the
2. Press the button and it will display the current time. If the time
is correct, go to point 4, and if not, adjust the time.
3. ADJUSTING THE CURRENT TIME: Use the "-" and "+" power
buttons in zone (B) to change the hour and use the "-" and "+"
timer buttons (E) to adjust the minutes.
4. Validate the time by pressing the
5. Adjust the time to when you wish cooking to finish with the " -" and
"+" buttons from zones (B) and (E).
6. Validate by pressing the
7. Adjust the cooking time using the "-" and "+" buttons in zone (E).
8. Validate by pressing the
9. Define the chosen power level for cooking with the
"-" and "+" buttons from zone (B).
10. Validate the power by pressing the
11. Once programmed, it displays (Auto) and then the digits go off
and only a red dot remains lit.
12
button.
button (the digits will then flash).
button.
button
button.