American Megatrends MegaRAC G2 User Manual page 138

MegaRAC G2 Card Flash Utility,
Step Description
1 Left click the Card Settings button to begin.
2 The Active Cards in Recovery Mode screen appears and starts to search for MegaRAC G2 cards in
Recovery Mode.
Left click the MegaRAC G2 card's MAC address that you want to configure.
The Active Cards in Recovery Mode buttons are explained in the table below:
Button Description
Stop The Stop button allows you to stop searching the network for active cards in Recovery
Mode.
Refresh The Refresh button allows you to start searching the network again for MegaRAC G2
cards' MAC addresses in Recovery Mode.
Select The Select button allows you to specify the highlighted MegaRAC G2 card's settings.
You can specify the MegaRAC G2 card's MAC, IP, Network Mask, and Gateway
addresses as shown in the following step.
Cancel The Cancel button allows you to cancel any new settings that are not saved.
128 MegaRAC G2 User's Guide
Continued
Cont'd