Led Indicators - D-Link DES-1012 User Manual

power cord into this connector, and the male into a power outlet.
Supported input voltages range from 100 ~ 240 VAC at 50 ~ 60 Hz.
Power Switch. This turns the Switch on and off. To turn on the
system, press the switch to the "1" position; to turn off, press the
switch to the "0" position.

LED Indicators

The LED indicators of the Switch include Power, 100 M, Link/Act
(Link/Activity) and FDX/Col (Full-duplex/Collision). The LED indicators
are used to facilitate monitoring and troubleshooting of the Switch. The
following shows the LED indicators for the Switch along with an explanation
of each indicator.
Power . This indicator operates when the Switch is turned on. If this
indicator is not lit, check the AC power connector to ensure proper
insertion of the power cord and that the power switch is turned ON.
100M . The LED indicator lights green when a 100 Mbps device is
connected to a respective port or the uplink port. If a 10 Mbps device
is connected to a respective port or the uplink port, the LED indicator
is OFF.
Link/Act . These LED indicators are lighted up green when there is a
secure connection (or link) to a device at any of the ports. The LED
Identifying External Components
10/100 Fast Ethernet Switch User's Guide
Figure 4, The Switch LED indicators
11