Onkyo TX-NR1010 Instruction Manual page 71

Audyssey DSX ®
■
Soundstage
–3dB to Reference to +3dB
With this setting, you can adjust the sound stage when using
Audyssey DSX.
Note
• This listening mode can be selected only when all the following
conditions are satisfied:
– The center speaker is connected.
– Either the front high or front wide speakers are connected.
– Powered Zone 2 is not in use.
Theater-Dimensional
■
Listening Angle
Wide:
Select if the listening angle is greater than 30 degrees.
Narrow:
Select if the listening angle is less than 30 degrees.
With this setting, you can optimize the Theater-
Dimensional listening mode by specifying the angle of the
front left and right speakers relative to the listening
position. Ideally, the front left and right speakers should be
equidistant from the listening position and at an angle close
to one of the two available settings.
Front left speaker Front right speaker
Listening angle: 30°
Note
Narrow
• For best results, we recommend setting "
"Wide" to 40°.
LFE Level
■
Dolby Digital , DTS
*1
TrueHD, DTS-HD Master Audio, DSD
–QdB, –20dB, –10dB, or 0dB
With these settings, you can set the level of the LFE (Low
Frequency Effects) channel individually for each input
sources.
If you find that low-frequency effects are too loud when
using one of these sources, change the setting to –20 dB or
–Q dB.
*1
Dolby Digital and Dolby Digital Plus sources
*2
DTS and DTS-HD High Resolution sources
*3 DSD (Super Audio CD) sources
Direct
■
Analog
Subwoofer
Off
On:
Analog audio signals (bass signals) are output.
This setting determines whether or not analog audio signals
(bass signals) are output from front speakers when the Pure
Audio or Direct listening mode is selected.
Note
• If the "Subwoofer" setting is set to "No"
setting cannot be selected.
• When Digital Processing Crossover Network is being used, this
setting is not available.
■
DSD
DAC Direct
Off
On:
" to 20° and
DSD signals are not processed by the DSP.
This setting determines whether or not DSD (Super Audio
CD) audio signals are passed through the DSP for A/V
, Multich PCM, Dolby
*2
*3
(➔ page 64), this
En-71
Advanced Operations
Sync, delay, etc., processing when the Pure Audio or
Direct listening mode is selected.
Note
• When Digital Processing Crossover Network is being used, this
setting is not available.
Sound Program Edit
■
Sound Program
Stereo Source 1, Stereo Source 2, Stereo Source 3,
Multich Source 1, Multich Source 2, Multich
Source 3
When playing back different content types on the same
source, or when listening to a single content type on
different sources, you can pre-register the settings that best
suit each content in "Sound Program". The registered
settings can then be called up and modified in one set. Use
"Sound Program Edit" to register and modify a
combination of settings.
Tip
• To select the registered settings, see "Sound Program"
(➔ page 55).
■
Listening Mode
You can assign a default listening mode that will be
selected automatically when you select the sound program.
The "Last Valid" option means that the listening mode
selected last will be used.
The "Straight Decode" option means that straight
decoding listening mode (Dolby Digital, DTS, etc.) is
selected.
■
Subwoofer
No, Yes
You can choose whether or not to use the subwoofer with
the sound program.
■
Music Optimizer
*1
Off, On
See "Music Optimizer" (➔ page 57).